HP 9000 rp3410 - Removing and Replacing the PCI Backplane; Removing the PCI Backplane

Chapter 6
Removing and Replacing Components
Removing and Replacing the PCI Backplane
205
Step 3. Install and tighten the bulkhead screw to hold the PCI card in place.
Step 4. Connect any cables that are required by the PCI card.
Step 5. Replace the PCI card cage. (See “Replacing the PCI Card Cage” on page 202.)
Step 6. Replace the top cover.
Step 7. Verify the PCI card replacement and operation by using the system utilities. (See the Utilities
chapter or the HP Integrity and HP 9000 iLO MP Operations Guide for additional information.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
Removing and Replacing the PCI Backplane
The HP 9000 rp 3410 and rp3440 server system backplane is called the PCI backplane and provides four PCI
card sockets. The removal process is the same for both.
Removing the PCI Backplane
Step 1. Remove the PCI card cage from the server. (See “Removing the PCI Card Cage” on page 200.)
Step 2. Remove all PCI and graphics cards. (See “Removing a PCI or Graphics Card” on page 203.)
Step 3. Unscrew the backplane mounting screws and slide the backplane board toward the bulkhead end of
the PCI card cage. This unlocks the backplane from its standoffs.