HP 9000 rp3410 - Replacing the Power Supply Interface Module; Figure 6-77 Replacing the Power Supply Interface Module; Figure 6-78 Securing the Power Supply Interface Module and Cables

Chapter 6
Removing and Replacing Components
Removing and Replacing the Power Supply Interface Module
226
Replacing the Power Supply Interface Module
Step 1. Place the PSI module into the chassis by sliding the module retaining tab into the socket on the
hard disk drive bay wall.
Figure 6-77 Replacing the Power Supply Interface Module
Step 2. Screw in the PSI module mounting screw and secure the power cables behind the holding clips.
Figure 6-78 Securing the Power Supply Interface Module and Cables
Step 3. Replace the system board. (See “Replacing the System Board” on page 217.)