HP 9000 rp3410 - Additional Controls and Indicators; Table 1-7. Control Panel Leds and Switches; Table 1-8 Hot-Pluggable Disk Drive LED Definitions; Figure 1-9 Hot-Pluggable Disk Drive LED Indicators

Chapter 1
Overview
Controls, Ports, and LEDs
37
Additional Controls and Indicators
HP 9000 rp3410 and rp3440 servers can have up to three low-voltage differential (LVD), 3.5-inch form factor
hot-pluggable disk drives installed. These disk drives have LEDs that provide status and activity
information.
Hot-Pluggable Disk Drive Indicators
The disk drives have two LEDs per drive, as follows:
• Status LED: Not used on the HP 9000 rp3410 or rp3440 server.
• Activity LED: Flashing green and indicates disk drive activity. This LED is directly controlled by the disk
drive and turns on when a drive is accessed.
Figure 1-9 shows the hot-pluggable disk drive LED indicators.
Figure 1-9 Hot-Pluggable Disk Drive LED Indicators
Table 1-8 lists the hot-pluggable disk drive LED definitions.
Optional Removable Media Drive
HP 9000 rp3410 and rp3440 servers are delivered without a removable media drive. You can add either a
DVD or CD-RW/DVD drive. Each of these optional devices has one activity LED.
Locator button
and LED
The locator button and LED are used to help locate this server within a rack of servers.
When the button is engaged, the blue LED illuminates and an additional blue LED on
the rear panel of the server illuminates. You can remotely activate this function.
Table 1-8 Hot-Pluggable Disk Drive LED Definitions
LED State Description
Status LED None Not used.
Activity LED Flashing green Reading and scanning hard drive
Table 1-7 Control Panel LEDs and Switches (Continued)
Name Function
Status LED
(Not Used)
Activity LED