HP 9000 rp3410 - Figure 3-6 Removing and Replacing the Top Cover on a Rack-Mounted Server; Figure 3-7 Aligning the Top Cover

Installing the System
Installing Additional Components
Chapter 3
65
Figure 3-6 Removing and Replacing the Top Cover on a Rack-Mounted Server
Step 3. Lift the cover off the server chassis.
Replacing the Top Cover on a Rack-Mounted Server
CAUTION Secure any wires or cables in the server so they will not get cut or interfere with the
replacement of the cover.
Step 1. Align the front edge of the cover with the alignment mark on the optical drive bay.
Figure 3-7 Aligning the Top Cover
To replace cover,
align front edge here
then slide forward