HP 9000 rp3410 - Figure 3-30 DIMM Slot Identification

Installing the System
Installing Additional Components
Chapter 3
85
Figure 3-30 DIMM Slot Identification
Installing System Memory
When adding DIMMs, you must use a minimum of four like-sized DIMMs in the next available quad. If you
are installing DIMMs of different sizes, you must install the largest DIMMs (most memory) in the first quad.
DIMMs in the second quad can be equal to or smaller than (less memory) the DIMMs in the first quad. If you
install DIMMs in the third quad, they must be equal to or smaller than the DIMMs in the second quad.
rp3410 Memory Configuration T
The HP 9000 rp3410 server supports DDR SDRAM DIMMs with ECC and chip spare protection. This server
has 12 DIMM slots and supports a maximum of six GB of total system memory. Memory usage in the server
varies with the model designation.
Rear
Front
Pair 3 (2A &
Pair 2 (1A&1B)
1A
1B
3A
3B
Pair 6 (5A&5B)
Pair 1 (0A&0B)
2A
0B
2B
0
Cell 1
Cell 0
4B
5B
5A
4A
Pair 5
Pair 4 (3A&3B)
Quad 1 = Pair 1 & Pair 2
Quad 2 = Pair 3 & Pair 4
Quad 3 = Pair 5 & Pair 6