Chapter 2
Installing and Configuring
Rear Panel
23
10/100/1000 Base-T Ethernet LAN Connector
The rear panel 10/100/1000 base-T ethernet LAN connector has the following status and activity LEDs.
Figure 2-6 10/100/1000 Base-T Ethernet LAN Connector LEDs
Locator button and
LED
The locator button and LED are used to help locate a server within a rack of
servers. When the button is engaged, the blue LED illuminates and an additional
blue LED on the front panel of the server illuminates. This function may be
remotely activated
Video (not used) 15-pin female video connector. DISABLED—DO NOT USE. To enable video
capability you must obtain the supported A6150 video PCI card. Refer to the
associated ReadMe, A6150-90001
Console/remote/UPS 25-pin female serial data bus connector for the iLO manageability card
10/100 iLO
manageability card
LAN
10 MB/100 MB LAN connector for the iLO manageability card
Table 2-5 10/100/1000 Base-T Ethernet LAN Connector LEDs
LED Description
1000BT Blinking green, the 1000 MHz with ethernet protocol and twisted-pair wiring is
enabled; off—no link
100BT Blinking green, the 100 MHz with ethernet protocol and twisted-pair wiring is
enabled; off—no link
10BT Blinking green, the 10 MHz with ethernet protocol and twisted-pair wiring is
enabled; off—no link
Activity Blinking green, LAN activity
Table 2-4 Rear Panel Connectors and Switches (Continued)
Connector/Switch Function
1000BT
100BT
10BT
Activity
To Next Page
Loading...
