Chapter 2
Installing and Configuring
Removing and Replacing System Covers and Bezels
26
Step 2. Release the rack latches by rotating them outward (Figure 2-8).
Figure 2-8 Release the Rack Latches
Step 3. Slide the system out of the rack until the guide-rail release clips are visible.
Insert the Server into the Rack
To insert the server into the rack, perform the following steps:
Step 1. Press the rail clips on either side of the server inward and push the server into the rack until it
stops.
Step 2. Verify that the rack latches are closed.
Removing and Replacing the Metal Cover
Removal of this cover is necessary when installing or removing many components.
Removing the Metal Cover
NOTE If you are replacing a hot-swappable item, you can leave the system on and external cables
(including the power cord) connected.
Step 1. Turn off the system and disconnect the power and external cables from the back of the system.
To Next Page
Loading...
