HP 9000 rp3440 - Figure 2-10 Aligning the Metal Cover; Figure 2-11 Closing the Metal Cover

Chapter 2
Installing and Configuring
Removing and Replacing System Covers and Bezels
28
Step 1. Align the front edge of the cover with the alignment mark on the optical drive bay (Figure 2-10).
Figure 2-10 Aligning the Metal Cover
Step 2. Grasp the blue release lever and slide the cover toward the front of the system until the lever snaps
into place (Figure 2-11).
Figure 2-11 Closing the Metal Cover
Step 3. Slide the system into the rack enclosure and reconnect the power and external cables.
To replace cover,
align front edge here
then slide forward