HP 9000 rp3440 - Figure 2-12 Front Bezel Retaining Clip

Chapter 2
Installing and Configuring
Removing and Replacing System Covers and Bezels
29
Removing and Replacing the Front Bezel
You must remove the front bezel from the chassis to gain access to the power supplies and optical drive.
Removing the Front Bezel
Step 1. Press in on the retaining clips located on the right-side of the front panel (Figure 2-12).
Figure 2-12 Front Bezel Retaining Clip
Step 2. Rotate the front panel outward and lift it off the system chassis.
Replacing the Front Bezel
Step 1. Insert the bezel latches into the matching slots on the system chassis.