HP 9000 rp3440 - Tower Configuration; Figure 2-13 Replacing the Front Bezel

Chapter 2
Installing and Configuring
Removing and Replacing System Covers and Bezels
30
Step 2. Close the bezel and push toward the front of the system until it locks into place (Figure 2-13).
Figure 2-13 Replacing the Front Bezel
Tower Configuration
NOTE If you are replacing a hot-swappable item, you can leave the system on and external cables
(including the power cord) connected.
Removing the Side Covers
Step 1. Turn off the system and disconnect the power and external cables.
Step 2. Remove the plastic cover.
a. Grasp both indentations at the top of the side panel and pull outward (Figure 2-14).