Chapter 2
Installing and Configuring
Installing a DVD-ROM Drive
39
Installing a DVD-ROM Drive
Install a DVD-ROM drive behind the front bezel.
WARNING Ensure that the system is powered-down and all power sources have been
disconnected from the server prior to removing or replacing a removable media
drive.
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning could result in personal injury or damage to
equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server. Failure to properly complete the steps
in this procedure will result in erratic system behavior or system failure. For assistance with
this procedure contact your local HP Authorized Service Provider.
Figure 2-25 DVD-ROM Drive Installation
To Next Page
Loading...
