Chapter 2
Installing and Configuring
Installing a DVD-ROM Drive
40
Installing the DVD-ROM Drive
To install a DVD-ROM drive, perform the following steps:
Step 1. Turn off the system and disconnect power and external cables.
Step 2. Remove the front bezel and cover. (See “Removing and Replacing System Covers and Bezels” on
page 25.)
Step 3. If a removable media drive has not previously been installed in the server, the drive slot will be
covered with a DVD drive filler. Remove the DVD drive filler.
Step 4. Slide the drive into the drive bay until it stops sliding and the retaining clips on both sides of the
drive snap into place (Figure 2-25).
Step 5. Connect the IDE cable on the back of the drive (Figure 2-25).
Step 6. Replace the cover and bezel. (See “Removing and Replacing System Covers and Bezels” on page 25.)
Step 7. Reconnect the power and external cables and turn on the system.
Step 8. Verify the drive operation by using the system utilities. (Refer to the Utilities chapter of the
HP9000 rp3410 and rp3440 Operations Guide for additional information.)
• Use the MP commands to verify operation
• Use the BCH commands to verify operation
• Use diagnostics provided by the offline diagnostic environment to exercise the newly installed
module
To Next Page
Loading...
