HP 9000 rp3440 - Figure 2-34 Inserting DIMM into Connector

Chapter 2
Installing and Configuring
Installing Additional System Memory
52
Step 5. Evenly push down firmly on each end of the DIMM until it seats in the socket. Ensure the
extraction levers are in the closed position.
Figure 2-34 Inserting DIMM into Connector
Step 6. Replace the memory airflow guide. (See “Replacing the Memory Airflow Guide” on page 42.)
Step 7. Replace the system cover. (See “Removing and Replacing the Metal Cover” on page 26.)
Step 8. Reconnect all power and external cables and turn on the system.
Step 9. Verify the memory installation by using the system utilities. (Refer to the Utilities chapter of the
HP 9000 rp3410 and HP 9000 rp3440 Operations Guide for additional information.)
• Use the MP commands to verify operation
• Use the BCH commands to verify operation
• Use diagnostics provided by the offline diagnostic environment (ODE) to exercise the memory
added