Chapter 2
Installing and Configuring
Installing PCI Cards
56
Step 3. Grasp the edges of the PCI card to be installed and evenly press the card into the PCI backplane
connector.
Figure 2-37 Installing a PCI Card
Step 4. Connect any internal cables that are required by the PCI card.
Step 5. Install the accessory card holder(s) and secure in place by tightening the associated bulkhead
screw(s).
Step 6. Reinstall the PCI cage. (See “Replacing the PCI Card Cage” on page 54.)
Step 7. Replace the cover. (See “Removing and Replacing the Metal Cover” on page 26.)
Step 8. Verify the PCI card installation by using the system utilities. (Refer to the Utilities chapter of the
HP 9000 rp3410 and HP 9000 rp3440 Operations Guide for additional information.)
• Use the MP commands to verify operation
• Use the BCH commands to verify operation
• Use diagnostics provided by the offline diagnostic environment to exercise the card added
To Next Page
Loading...
