Chapter 2
Installing and Configuring
Installing an Additional Processor Module
60
Step 5. Unlock the dual processor module locking mechanism using the CPU install tool (2.5mm Driver or
Allen Wrench). Insert the tool into the hole that runs down through the edge of the heatsink and
rotate the special processor tool 180 degrees counterclockwise. Verify that the dual processor
module socket locking mechanism is rotated into the unlocked position (Figure 2-40).
Figure 2-40 Unlocking the Dual Processor Module Locking Mechanism
Step 6. Remove any protective packaging from the processor module.
NOTE Protective covers may be installed to protect connector pins. These covers can be
saved for future use.
CPU Install Tool
(2.5mm Driver or
Allen Wrench)
To Next Page
Loading...
