HP 9000 rp3440 - Figure 2-44 Secure the Captive Screws; Figure 2-45 Power Module Shims

Chapter 2
Installing and Configuring
Installing an Additional Processor Module
63
Step 10. Screw in the four heatsink captive screws. Tighten the screws in a criss-cross pattern.
Figure 2-44 Secure the Captive Screws
Step 11. Locate the two power pod module shims on the system board. (On systems delivered with only one
dual processor module installed, the power module shims are held in place by screws with plastic
spacers over the threads.) Remove the holding screws and discard the plastic spacers. Retain the
screws for use when installing the power module.
Figure 2-45 Power Module Shims
CPU Install Tool
(Torx T15)
Shims
Spacers
Screws