Cable Connections
Booting the Server
Chapter 4
90
Booting the Server
To boot the server, press the power switch located to the left of the front panel LEDs.
NOTE If the front bezel is attached and in the closed position, you will need to open the small door on
the front bezel to gain access to the power switch.
If the autoboot function is enabled, the system will boot to the installed operating system. If autoboot is not
enabled, the system will enter the boot console handler BCH. The BCH allows you to control the server’s
booting environment. For more information about the BCH, review the Utilities chapter of the Operations
Guide.
To Next Page
Loading...
