HP 9000 rp4440 - Removing a DVD Drive; Replacing a DVD Drive; Figure 4-39 DVD Drive Removal and Replacement

Chapter 4
Removing and Replacing Components
DVD Drive
104
Figure 4-39 DVD Drive Removal and Replacement
Removing a DVD Drive
To remove a DVD drive, perform the following steps:
Step 1. Grasp the front of the DVD drive and squeeze in on the locking tab to release the drive.
Step 2. Remove the front bezel. (Refer to “Front Bezel” on page 38.)
Step 3. Pull the drive straight out to remove it from the chassis.
Replacing a DVD Drive
To replace a DVD drive, perform the following steps:
Step 1. Grasp the front of the DVD drive and squeeze in on the locking tab to release the drive.
Step 2. Push the drive straight into the drive bay until the locking tab clicks into place.
Step 3. Replace the front bezel.