HP 9000 rp4440 - Front and Top Covers; Removing the Front Cover; Figure 4-4 Removing and Replacing the

Chapter 4
Removing and Replacing Components
Front and Top Covers
39
Front and Top Covers
NOTE When the front or top cover is removed the chassis fan units increase to high speed to assist
cooling. When the top cover is replaced at the end of the operation, the chassis fans return to
normal speed.
Figure 4-4 Removing and Replacing the Front Cover
Removing the Front Cover
To remove the front cover, perform the following steps:
WARNING Hazardous voltages are present inside the HP Server. Always remove the AC power
cords from the server and associated assemblies while working inside the unit.
Serious injury may result if this warning is not observed.
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. (Refer to the hp9000 rp4440
Installation Guide for additional information.)
Step 2. Remove the front bezel. (Refer to “Front Bezel” on page 38.)
Thumbscrews