HP 9000 rp4440 - Replacing the Front Cover

Chapter 4
Removing and Replacing Components
Front and Top Covers
40
Step 3. Using a Torx T15 driver, loosen the four captive thumbscrews that hold the front cover in place.
Step 4. Raise the cover slightly, and pull the cover toward the front of the server to free the tabs from the
slots in the center of the chassis.
Replacing the Front Cover
To replace the front cover, perform the following steps:
Step 1. Align the tabs at the rear of the front cover with the corresponding slots in the chassis and fully
seat the tabs into the slots.
Step 2. Tighten the four thumbscrews securely.
Step 3. Replace the front bezel.
Step 4. If rack mounted, slide the HP Server into the rack until it stops.