HP 9000 rp4440 - Figure 4-15 Processor Cable Placed Correctly; Figure 4-16 Processor Cable Placed Incorrectly

Chapter 4
Removing and Replacing Components
Processors
60
Figure 4-15 Processor Cable Placed Correctly
Figure 4-16 Processor Cable Placed Incorrectly
Step 7. Using a CPU install tool (2.5 mm driver or Allen wrench), lock the assembly to the socket by
rotating the cam on the socket 180 degrees clockwise.
CAUTION When rotating the locking cam, hold the palm of your hand on top of the assembly
and exert light pressure. This ensures that the assembly stays flush and level to the
socket while it is being tightened.
Step 8. Plug in the processor cable to its socket on the extender board.
Step 9. Place the sequencer frame over the processor.
Step 10. Using your fingers, hand-tighten the 2 knurled thumbscrews on the sequencer frame just until the
screw stops turning.
Cable is placed correctly and
is under
the heatsink
Sheet Metal Frame
Heatsink
Protective Plastic Sleeve
Cable is placed
incorrectly and is pinched
between the heatsink and
the extender board frame
Sheet Metal Frame
Heatsink
Protective Plastic Sleeve