HP 9000 rp4440 - Figure 4-17. Installing Processor on Extender Board

Chapter 4
Removing and Replacing Components
Processors
62
Figure 4-17 Installing Processor on Extender Board
4
2
3
1
Tightening sequence for 4-shoulder
screws is 1, 2, 3, 4.
DO NOT OVERTIGHTEN! See Step 7.
2-knurled
Thumb-
screws
Align pins on
heatsink with
slots in frame
Power cable (Protected by
plastic sleeve)
Slots*
Slots*
*Slots shown are at
CPU socket #1 for
clarity.
Processor shown is
being mounted on
socket #0 per CPU load
order.
TCPU Install Tool
(Torx-T15) tighten
shoulder screws
and thumbscrews
2.5 mm Allen