HP 9000 rp4440 - Replacing a PCI Card; Figure 4-25 OLX Divider

Chapter 4
Removing and Replacing Components
Removing and Replacing PCI/PCI-X Cards
76
Figure 4-25 OLX Divider
Replacing a PCI Card
To replace a PCI card, perform the following steps:
Step 1. Insert the card into the appropriate slot. See Figure 4-26 on page 78.
Step 2. Turn the PCI/PCI-X card latch on the chassis to ~45 degrees CCW to allow closing of the manual
retention latch (MRL).
Step 3. Push down on the MRL until it stops against the chassis wall.
Step 4. Turn the PCI/PCI-X card latch on the chassis another 45 degrees CCW to lock the PCI/PCI-X card
into position.
Manual Retention
Latch (closed position)
Manual
Retention
Latch (open
position)
PCI-X Card
Latch (open
position)
Power LED
Light Pipe
Attention
Button
Attention LED
Light Pipe
PCI-X Card Latch
(closed position)