HP 9000 rp4440 - Removing a Voltage Regulator Module (VRM); Figure 4-31 VRM Board Remove and Replace

Chapter 4
Removing and Replacing Components
Voltage Regulator Modules (VRM)
86
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Figure 4-31 VRM Board Remove and Replace
Removing a Voltage Regulator Module (VRM)
To remove a VRM from the server, perform the following steps:
Step 1. Remove the I/O baseboard from the chassis. (Refer to “I/O Baseboard Assembly” on page 67.)
Step 2. Push out the locking tabs at the end of the VRM slot to release it, then pull the VRM straight out of
the I/O baseboard.
12V VRM
3.3V VRM
5V VRM