HP 9000 rp4440 - Figure 4-36 Midplane Riser Board

Chapter 4
Removing and Replacing Components
Midplane Riser Board
95
Step 12. Using a Torx #15 driver, remove the five Torx screws attaching the midplane riser board to the
chassis.
Step 13. Grasp the top edge of the midplane riser board and lift straight up to release it from the keyway
slots on the chassis. Then pull straight out and up to remove the midplane riser board from the
chassis.
Figure 4-36 Midplane Riser Board
2
4
1
5
3
Midplane Riser
Board
1-5
Attaching
Screw
Locations