HP 9000 Superdome - Removing the Rear EMI Panel

Appendix G
Connecting Multiple SPU Cabinets
Removing the Rear EMI Panel
184
Removing the Rear EMI Panel
To make the necessary switch settings and to connect the proper cables, you’ll need to remove the back EMI
panel from each cabinet.
To remove the back EMI panel:
Step 1. Loosen the captive screw at the lower center of the back EMI panel.
Figure G-3Removing the Back EMI Panel
Step 2. Use the handle provided to gently remove the EMI panel and set it aside.
Step 3. Remove the EMI panel for the other cabinet shipped with the system.
60IN025A
9/8/00
L
2
-
L
3
L
1
-L
2
L
3
-
L
1
L
2
-L
3
L
1
-L
2
L
3
-
L
1
Back EMI Panel Screw