HP 9000 Superdome - JET Update Configuration Menu

Appendix H
JUST Exploration Tool
JET Interactive Mode
213
Link: source node = 0 BACKPLANE TOGO_FLEX_0
Link: source node = 0 BACKPLANE TOGO_FLEX_3
Link: source node = 0 BACKPLANE TOGO_FLEX_6
Link: source node = 0 BACKPLANE TOGO_FLEX_5
Link: source node = 1 BACKPLANE TOGO_FLEX_7
Link: source node = 1 BACKPLANE TOGO_FLEX_4
Link: source node = 1 BACKPLANE TOGO_FLEX_0
Link: source node = 1 BACKPLANE TOGO_FLEX_2
Link: source node = 1 BACKPLANE TOGO_FLEX_6
Link: source node = 1 BACKPLANE TOGO_FLEX_5
Link: source node = 1 BACKPLANE TOGO_FLEX_1
Link: source node = 1 BACKPLANE TOGO_FLEX_3
------------------------------------------------------------------------
JET Update Configuration Menu
To update the configuration in a complex, 3 from the main JET menu as shown in Figure H-10.
Figure H-10 Interactive Mode Display
% jet -i
JET Interactive MAIN MENU!
Select from the following options.
1) Run JET.
2) Display current configuration data.
3) Update configuration.
X) Exit
Enter selection:
When selecting the Update Configuration Option, the menu shown in Figure H-11 is displayed, which shows
a list of available complexes. Select the desired complex.
Figure H-11 Update Configuration Main Menu
JET Interactive COMPLEX SELECTION MENU!
Select from the following options.
1) feynman-s.
X) Return to previous menu.
Enter selection: 1
Figure H-12 Update Configuration Options Menu
JET Interactive Update menu.
Select from the following options.
1) Load new node configuration file.
2) Add a Board to an existing node.
3) Remove a Board from an existing node.
4) Load flex mate file.
5) Add a Link.
6) Remove a Link.
X) Return to previous menu.
Enter selection: 2