Chapter 3
Preparing Superdome for Booting
Unpacking and Installing the Blower Housings and Blowers
31
Unpacking and Installing the Blower Housings and Blowers
There are two blower housings and four blowers for each SPU cabinet. Although similar in size, the blower
housings for each SPU cabinet are not the same; one has a connector to which the other attaches. Use the
following procedure to unpack and install the housings and blowers:
Step 1. Unpack the housings from the cardboard box and set them aside.
The rear housing is labeled Blower 3 Blower 2. The front housing is labeled Blower 0 Blower 1.
CAUTION Do not lift the housing by the stiffener. You can damage it.
Figure 3-1Blower Housing Stiffener
Step 2. Remove the cardboard from the blower housing.
5/31/01
60IN030A
Blower Housing Stiffener
Handles
To Next Page
Loading...
