Chapter 3
Preparing Superdome for Booting
Removing the EMI Panels
53
Removing the EMI Panels
Remove the front and back electromagnetic interference (EMI) panels to access ports on the Superdome and
to visually check whether components are in place and the LEDs are properly illuminated when you apply
power to the system.
To remove the front and back EMI panels:
Step 1. Using a T20 Torx driver, loosen the captive screw at the top center of the front EMI panel.
Figure 3-19Removing Front EMI Panel Screw
Step 2. Use the handle provided to remove the EMI panel and set it aside.
When in position, the EMI panels (front and back) are tightly in place. Removing them takes
controlled, but firm, exertion.
60IN024A
8/8/00
Front EMI Panel Screw
To Next Page
Loading...
