HP 9x9KS Series Installation And Service Manual

Step No.
3.6
Configuring MPE
Prompt and Response
After you respond to all the prompts for one device,
this LOGICAL DEVICE #? prompt is repeated to allow for
configuring additional devices. If I/O configuration
is complete, press RETURN and the system configuration
dialogue continues with step 3.80.
ORT #?
_Q_
Removes the device specified in the previous
prompt from the current MPE configuration.
xx Enters the hardware DRT number for the INP.
3. 7 UN r·r #? o
3. 8 SOFTWARE CHANNEL #? Q.
3.9 TYPE? l1
3.10 SUBTYPE?
l..
(IML/3000)
0 or l
(RJE/3000 and MRJE/3000)
(DS/3000)
_Q_, _!., or 3
0 = Synchronous switched line with a modem
l = Synchronous nonswitched line with a modern
3 = Synchronou~ nonswitched line, hardwired
I
(Note: If the INP is hardwired directly to an SSLC, I
always configure both the INP and the SSLC as Subtype 1
and Transmission Mode 1. )
3.17
3.18
3.19
JUN 1980
RECEIVE rrIMEOUT?
0-32000 or return
return
LOCAL TIMEOU'I1?
0-32000 or return
return
COIHJECT rrIMEOUT?
0-32000 or return
return
(20-second default)
(DS/3000 and RJE/3000)
(MRJE/3000 and H1L/3000 override
this option)
(60-second default)
(DS/3000 and RJE/3000)
(MRJE/3000 and IML/3000 override
this option)
(900-second default)
(DS/3000 and RJE/3000)
(MRJE/3000 and IML/3000 override
this option)
C-3
I
I
I

HP 9x9KS Series Specifications

General

Brand	HP
Model	9x9KS Series
Category	Desktop
Language	English