System ROM
Storage controller
Network adapters
Set up storageSet up storage
7. To set up storage, do one of the following:
To configure the server to boot from a SAN, see the HPE Boot from SAN Configuration Guide guide at
https://www.hpe.com/info/boot-from-san-config-guidehttps://www.hpe.com/info/boot-from-san-config-guide.
If a storage controller is installed:
For SR controllers, use HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator .
For more information, see the HPE Smart Array SR Gen10 Configuration Guide at https://www.hpe.com/support/SSC-confighttps://www.hpe.com/support/SSC-config.
For MR controllers, use the UEFI System Utilities to create arrays.
For more information, see the HPE Smart Array P824i-p MR Gen10 User Guide guide at http://www.hpe.com/info/P824i-p-docshttp://www.hpe.com/info/P824i-p-docs.
IMPORTANT:IMPORTANT:
MR controllers are not supported by Intelligent Provisioning or Smart Storage Administrator.
IMPORTANT:IMPORTANT:
Before you install an OS on drives connected to this controller, configure the drives using UEFI System Utilities
(F9). If the drives are not configured, the OS will not detect the drives during installation. For more information,
see the controller's user guide at the Hewlett Packard Enterprise websiteHewlett Packard Enterprise website .
If no controller is installed, do one of the following:
AHCI is enabled by default. Proceed with deploying an OS or virtualization software.
Disable AHCI, enable software RAID, and then create an array:
IMPORTANT:IMPORTANT:
HPE Smart Array S100i SR Gen10 SW RAID is only supported on Windows. For more information on Linux and
VMware support, see the product QuickSpecs on the Hewlett Packard Enterprise website
(https://www.hpe.com/support/S100i-qshttps://www.hpe.com/support/S100i-qs).
a. From the boot screen, press F9 to run UEFI System Utilities.
b. Select System Configurations > BIOS/Platform Configuration (RBSU) > Storage Options > SATA Controller Options >
Embedded SATA configuration > Smart Array SW RAID Support .
c. Enable SW RAID.
d. Save the configuration and reboot the server.
e. Create an array using either the UEFI System Utilities or HPE Smart Storage Administrator. To use the UEFI System Utilities:
i. From the boot screen, press F9 to run UEFI System Utilities.
ii. Select System Configuration > Embedded Storage: HPE Smart Storage S100i SR Gen10 > Array Configuration > Create
Array.
For more information on creating arrays using the HPE Smart Storage Administrator , see the HPE Smart Array SR Gen10
Configuration Guide at https://www.hpe.com/support/SSC-confighttps://www.hpe.com/support/SSC-config.
Deploy an OS or virtualization softwareDeploy an OS or virtualization software
To Next Page
Loading...
