WARNING:WARNING:
When all components are removed, the storage server weighs 21.67 kg (47.78 lb). When all components are installed, the
storage server can weigh up to 42.84 kg (94.45 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and specifications. Failure to do
so can result in physical injury or damage to the equipment and the facility.
WARNING:WARNING:
The storage server is heavy. To reduce the risk of personal injury or damage to the equipment, do the following:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened to
the rails. The storage server weighs more than 21.67 kg (47.78 lb), so at least two people must lift the storage server
into the chassis together. An additional person may be required to help align the storage server if the storage server is
installed higher than chest level.
Use caution when installing the storage server in or removing the storage server from the chassis.
Adequately stabilized the chassis before extending a component outside the chassis. Extend only one component at a
time. A chassis may become unstable if more than one component is extended.
Do not stack anything on top of rail-mounted component or use it as a work surface when extended from the rack.
WARNING:WARNING:
To reduce the risk of personal injury or damage to the equipment, observe the following precautions:
The leveling jacks are extended to the floor.
The full weight of the rack rests on the leveling jacks.
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple-rack installations.
WARNING:WARNING:
To reduce the risk of personal injury or equipment damage when unloading a rack:
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack can weigh as much as 115
kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might become unstable when being moved on its casters.
Never stand in front of the rack when it is rolling down the ramp from the pallet. Always handle the rack from both
sides.
CAUTION:CAUTION:
Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install the heaviest item first, and
continue to populate the rack from the bottom to the top.
CAUTION:CAUTION:
Before installing the storage server in a chassis, be sure to properly scope the limitations of the chassis. Before proceeding
with the installation, consider the following:
You must fully understand the static and dynamic load carrying capacity of the chassis and be sure that it can
accommodate the weight of the storage server.
Be sure sufficient clearance exists for cabling, installation and removal of the storage server, and movement of the rack
doors.
Installing the product in a rackInstalling the product in a rack
To Next Page
Loading...
