WARNING:WARNING:
To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into grounded (earthed) electrical outlet that is easily accessible at all times.
To disconnect power to the equipment, unplug the power cord from the power supply.
Do not route the power cord where it can be walked on or pinched by items placed against it. Pay particular
attention to the plug, electrical outlet, and the point where the cord extends from the storage server.
7. Connect the power cord to the power source.
Installing the operating systemInstalling the operating system
About this taskAbout this task
To operate properly, the server must have a supported operating system. For the latest information on operating system support, see the
Hewlett Packard Enterprise website (https://www.hpe.com/us/en/servers/server-operating-systems.htmlhttps://www.hpe.com/us/en/servers/server-operating-systems.html).
IMPORTANT:IMPORTANT:
HPE ProLiant XL servers do not support operating system installation with Intelligent Provisioning, but they do support the
maintenance features. For more information, see "Performing Maintenance" in the
HPE Intelligent Provisioning User Guide
and online help.
For additional system software and firmware updates, download the Service Pack for ProLiant from the Hewlett Packard Enterprise website
(http://www.hpe.com/servers/spp/downloadhttp://www.hpe.com/servers/spp/download). Software and firmware must be updated before using the server for the first time, unless any
installed software or components require an older version.
For more information on using these installation methods, see the Hewlett Packard Enterprise website
(https://www.hpe.com/us/en/servers/integrated-lights-out-ilo.htmlhttps://www.hpe.com/us/en/servers/integrated-lights-out-ilo.html).
Selecting boot options in UEFI Boot ModeSelecting boot options in UEFI Boot Mode
About this taskAbout this task
On servers operating in UEFI Boot Mode, the boot controller and boot order are set automatically.
ProcedureProcedure
1. Press the Power On/Standby button.
2. During the initial boot:
To modify the server configuration ROM default settings, press the F9F9 key in the ProLiant POST screen to enter the UEFI System
Utilities screen. By default, the System Utilities menus are in the English language.
If you do not need to modify the server configuration and are ready to install the system software, press the F10F10 key to access
Intelligent Provisioning.
ResultsResults
For more information on automatic configuration, see the UEFI documentation on the Hewlett Packard Enterprise websiteHewlett Packard Enterprise website .
To Next Page
Loading...
