ItemItem DescriptionDescription StatusStatus
1 UID button/LED
Solid blue = Activated
Flashing blue:
1 flash per second = Remote management or firmware upgrade in progress
4 flashes per second = iLO manual reboot sequence initiated
8 flashes per second = iLO manual reboot sequence in progress
1 fast flash and then off for 3 seconds = iLO Service Port status is
Complete
4 medium flashes and then off for 1 second = iLO Service Port status is
Busy
8 fast flashes and then off for 1 second = iLO Service Port status is Error
Off = Deactivated
2 NIC status LED
Solid green = Link to network
Flashing green (1 flash per second) = Network active
Off = No network activity
3 Health LED
Solid green = Normal
Flashing green (1 flash per sec) = iLO is rebooting
Flashing amber = System degraded
Flashing red (1 flash per sec) = System critical
4 Power On/Standby button and system
power LED
Solid green = System on
Flashing green (1 flash per second) = Performing power on sequence
Solid amber = System in standby
Off = No power present
When these four LEDs flash simultaneously, a power fault has occurred.
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
front I/O cable is disconnected.
1
1
1
2
1
3
1
2
3
To Next Page
Loading...
