HP ap5000 - All-in-One Point of Sale System - Removing the Drive Cover; Replacing the Drive Cover

Removing the Drive Cover
To remove the drive cover, loosen the screw that holds the cover in place (1), rotate the cover back (2),
and pull the cover off the display head (3).
NOTE: The drive cover screw is captive, therefore it does not disengage from the drive cover when
loosened.
Figure 2-5 Removing the Drive Cover
Replacing the Drive Cover
To replace the drive cover, slide the tabs on the cover into the slots on the side of the display (1), rotate
the cover onto the display (2), then tighten the screw (3).
Figure 2-6 Replacing the Drive Cover
8 Chapter 2 Hardware Upgrades ENWW