Replacing the Hard Drive
61
7 Carefully insert the two metal retention pins in the holes on the
underside of the hard drive, and ensure that the middle screw hole is
facing the tray’s alignment window.
8 Push down on the drive then tilt it towards the PC chassis until the
middle screw hole appears in the tray’s alignment window.
9 Tighten the two thumb screws.
10 Reconnect the power and data cables. Refer to “Cables and Connectors
in Your PC” on page 57 if you are unsure of which cables to use.
11 Replace the power supply unit.
12 Replace the PC’s main cover. Refer to page 54.
To Next Page
Loading...
