Connector board
Table 5-6 Connector board spare part information
Description Spare part number
Connector board (includes audio jack and USB port and rubber bumper) L92816-001
Before removing the connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 24).
5. Disconnect the battery cable from the system board (see Battery on page 32).
Remove the connector board:
1. Release the shielding (1) that covers the connector board cable ZIF connectors on the system board.
2. Release the ZIF connectors (2) to which the connector board cables are connected, and then disconnect
the connector board cables from the system board.
3. Remove the two Phillips M2.0×4.2 screws (3) that secure the connector board to the bottom cover.
4. Remove the left-side I/O bracket (4).
The left-side I/O bracket is available using spare part number L89793-001.
5. Remove the connector board (5) and cables.
Component replacement procedures 37
To Next Page
Loading...
