17. Release the display panel cable from the retention clips (1) and routing channel built into the bottom edge
of the display back cover.
18. Remove the display panel (2).
● M44257-001: 29.5 cm (11.6 in), LCD, HD (1366×768), antiglare, WLED, UWVA, 50% CG, eDP 1.2
without PSR, slim touchscreen display panel; typical brightness: 220 nits
● M44256-001: 29.5 cm (11.6 in), LCD, HD (1366×768), antiglare, WLED, UWVA, 50% CG eDP, slim non-
touchscreen display panel; typical brightness: 220 nits
● M44255-001: 29.5 cm (11.6 in), LCD, HD (1366×768), antiglare, WLED, SVA, 45% CG, eDP, slim non-
touchscreen display panel; typical brightness: 220 nits
19. Turn the display panel upside down with the bottom edge toward you.
20. Release the grounding tape (1) that secures the display panel cable to the display panel.
21. Release the retention bar (2) that secures the display panel cable to the display panel.
22. Disconnect the display panel cable (3) from the display panel.
23. Remove the display panel cable.
ENWW Component replacement procedures 43
To Next Page
Loading...
