24. Remove the webcam/microphone module cable from the retention clips (1) and routing channels built into
the display back cover.
25. Detach the webcam/microphone module (2) from the display back cover. (The webcam/microphone
module is attached to the display back cover with double-sided adhesive.)
26. Release the ZIF connector to which the webcam/microphone module is connected, and then disconnect the
webcam/microphone module cable from the webcam/microphone module.
The webcam/microphone module is available using spare part number M44253-001. The webcam/
microphone module cable is included in the Cable Kit, spare part number M44247-001.
27. Remove the four Phillips M2.5 × 4.7 screws (1) that secure the display hinges to the bottom cover.
44 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
