3. Spread the latches apart on each side of the DIMM slot. Lift the DIMM up at an angle, and pull it
out.
Reinstallation tip Hold the DIMM by the edges. Align the notch on the DIMM with the bar in the
DIMM slot at an angle and firmly press the DIMM into the slot until it is fully seated. When installed
correctly, the metal contacts are not visible. Push down on the DIMM until both latches engage the
DIMM.
Figure 6-16 Remove the memory DIMM (2 of 2)
Enable memory for Windows
Use the following procedure to enable the memory if you are installing a new DIMM.
1. Windows XP, Windows Server 2003, and Windows Server 2008 (using the default Start
menuview): Click Start, click Settings, and then click Printers and Faxes.
-or-
Windows XP, Windows Server 2003, and Windows Server 2008 (using the Classic Start
menuview): Click Start, click Settings, and then click Printers.
-or-
Windows Vista: Click Start, click Control Panel, and then in the category for Hardware and
Sound click Printer.
2. Right-click the driver icon, and then select Properties.
3. Click the Device Settings tab.
4. Expand the area for Installable Options.
5. Select the total amount of memory installed in the product.
6. Next to Automatic Configuration, select Update Now.
7. Click OK.
194 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...
