D fuser (fixing) delivery sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser assembly, and then verify that the sensor flag on the fuser assembly moves
freely. If the sensor flag does not move freely, replace the fuser. See
Fuser on page 200.
Figure 7-6 Test the fuser delivery sensor (1 of 2)
4. Insert a piece of paper to activate the fuser (fixing) delivery sensor.
Figure 7-7 Test the fuser (fixing) delivery sensor (2 of 2)
5. Check the control-panel display for a sensor response.
6. If there is no response, replace the fuser (fixing) delivery sensor.
ENWW Tools for troubleshooting 391
To Next Page
Loading...
