H fuser (fixing) pressure-release sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser, and then rotate the gear (callout 1) to move the flag (callout 2). If the flag does
not actuate, replace the fuser. See
Fuser on page 200.
Figure 7-10 Test the fuser (fixing) pressure-release sensor (1 of 2)
2
1
4. Insert a piece of paper to activate the fuser (fixing) pressure-release sensor.
Figure 7-11 Test the fuser (fixing) pressure-release sensor (2 of 2)
5. Check the control-panel display for sensor response.
6. If there is no response, replace fuser (fixing) pressure-release sensor.
ENWW Tools for troubleshooting 395
To Next Page
Loading...
