I primary transfer-roller disengagement sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the ITB.
4. Rotate the gear (callout 1) to move the flag (callout 2). If the flag does not actuate, replace the ITB.
See
Intermediate transfer belt (ITB) on page 209.
Figure 7-12 Test the primary transfer-roller disengagement sensor (1 of 2)
1
2
5. Remove all print cartridges.
NOTE: Cover all removed print cartridges with paper.
6. Locate the sensor behind the cyan OPC drum position.
396 Chapter 7 Solve problems ENWW
To Next Page
Loading...
