4. Press Enter.
5. When prompted for the user name, press Enter.
6. When prompted for the password, press Enter.
7. Type bin at the command prompt.
8. Press Enter. The message 200 Type set to I, Using binary mode to transfer files appears in the
command window.
9. Type put <FILENAME>, where <FILENAME> is the name of the .RFU file that was downloaded
from the Web, including the path. For example, type put C:\CLJ\xxxxFW.RFU, and then press
Enter.
NOTE: If the file name or path includes a space, you must enclose the file name or path in
quotation marks. For example, type put "c:\My Documents\CLJ\xxxxfw.rfu".
The following series of messages appears in the command window:
200 PORT command successful
150 Opening BINARY mode data connection
226 Ready
226 Processing Job
226 Transfer complete
After these messages appear, a message containing transfer-speed information appears.
The download process begins and the firmware is updated on the product. This can take several
minutes. Let the process finish without further interaction with the product or the computer. The
messages described in
Messages during the firmware update on page 269 appear on the control
panel.
NOTE: The product automatically turns off and then on again to activate the update; this can
happen more than once. At the end of the update process, the READY message appears on the
control panel. Do not turn off the product or interfere with the update until you see this message.
10. When the product is in a Ready state, print a configuration page and verify that the firmware version
has changed.
11. At the command prompt, type bye to exit the FTP command.
12. At the command prompt, type exit to return to the Windows interface.
13. When the product is in a Ready state, print a configuration page and verify that the firmware version
has changed. Also, print the Menu map and check for settings changes.
266 Chapter 6 Engineering details ENWW
To Next Page
Loading...
