HP Color LaserJet CM1312 - Multifunction Printer - Page 197

Fuser
1. Remove the following components:
●
Right cover. See
Right cover on page 132.
●
Left cover. See
Left cover on page 135.
●
Front-right cover. See
Front-right cover on page 137.
●
Rear-side cover. See
Rear-side cover on page 142.
●
Rear-upper cover. See
Rear-upper cover on page 143.
●
Rear door and rear-lower cover. See
Rear door and rear-lower cover on page 145.
●
Scanner assembly. See
Scanner assembly on page 147.
●
Top cover. See
Top cover on page 149.
2. Remove two screws (callout 1) and the power-supply cover (callout 2).
Figure 6-119 Remove the fuser (1 of 4)
1
2
ENWW Internal assemblies 183