HP Color LaserJet CM1312 Series - Page 184

3. Disconnect two wire-harness connectors (callout 2) and release the wire harness from the retainer
(callout 3).
Figure 6-95 Remove the power supply (high-voltage; 2 of 7)
3
2
4. Remove one screw (callout 4) and then release the sub-PCA from the chassis (callout 5).
Figure 6-96 Remove the power supply (high-voltage; 3 of 7)
5
4
170 Chapter 6 Removal and replacement ENWW