Fuser
1. Remove the following components:
●
Right cover. See
Right cover on page 103.
●
Left cover. See
Left cover on page 105.
●
Control-panel module and memory-card reader. See
Control-panel module and photo-card
reader PCA on page 111.
NOTE: The HP Color LaserJet CP1210 Series Printer does not have a memory-card reader.
●
Rear-side cover. See
Rear-side cover on page 115.
●
Rear-upper cover. See
Rear-upper cover on page 116.
●
Rear door and rear-lower cover. See
Rear door and rear-lower cover on page 117.
●
Top cover. See
Top cover on page 119.
2. Remove two screws (callout 1) and the power-supply cover (callout 2).
Figure 6-85 Remove the fuser (1 of 4)
1
2
ENWW Internal assemblies 149
To Next Page
Loading...