Restoring the default settings unlocks menus that have been previously locked and resets all control-
panel menu items to the factory defaults. It does not reset the serial number and the page counts.
NOTE: Before restoring defaults, print a menu structure report and a configuration page. Use the
information on these pages to reset customer-specific settings.
CAUTION: All HP Jetdirect settings are also reset. Be sure to print a configuration page before
restoring defaults. Make note of the IP address that is listed on the Jetdirect configuration page. You
might need to restore the IP address after performing a cold reset.
NVRAM initialization
CAUTION: All HP Jetdirect settings are also reset. Be sure to print a configuration page before
performing an NVRAM initialization. Make note of the IP address that is listed on the Jetdirect
configuration page. You need to restore the IP address after performing an NVRAM initialization.
Performing an NVRAM initialization resets the following settings and information:
●
All menu settings are reset to factory default values.
●
All localization settings, including language and country/region, are reset.
After performing an NVRAM initialization, reconfigure any computers that print to this product so that
the computers can recognize the product.
Perform an NVRAM initialization on the HP Color LaserJet CP1210 Series printer
1. Turn the product off.
2. Press and hold the Resume button.
3. Turn the product on, and continue holding the Resume button for at least 10 seconds, but not longer
than 20 seconds. The Attention light will be lit.
4. Release the Resume button.
NOTE: If the Attention and either the Paper out light or the Ready light are lit, restart the
procedure.
The Attention, Ready, and Resume lights cycle from front to back until the process is complete.
The product then enters the Ready state.
Perform an NVRAM initialization on the HP Color LaserJet CP1510 Series printer
1. Turn the product off.
2. Simultaneously press the Right arrow
button and the X button. Keep these buttons depressed
as you turn the product on.
3. When Permanent storage init. appears on the display, release both buttons.
4. When the product has finished the NVRAM initialization, it returns to the Ready state.
204 Chapter 7 Problem solve ENWW
To Next Page
Loading...