Rear-lower cover and rear-door links (duplex product)
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 111.
●
Rear door (duplex products). See
Rear door (duplex product) on page 106.
2. Use a pair of needle-nose pliers to release two tabs, and then remove the rear-door link cap. Repeat
this step for the remaining rear-door link cap.
Figure 6-54 Remove the rear-lower cover and rear-door links (duplex product) (1 of 6)
3. Open the duplex feed assembly.
4. Release one tab (callout 1) and slightly separate the cover from the product.
Figure 6-55 Remove the rear-lower cover and rear-door links (duplex product) (2 of 6)
1
116 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...