7. Slightly lift up the rear-door rib assembly, and then carefully slide the cover away from the product
to remove it.
Figure 6-58 Remove the rear-lower cover and link-guides (duplex product) (5 of 6)
8. Rotate the rear-door link until the slot in the link aligns with the tap on the link-hinge pin, and then
remove the rear-door link. Repeat this step for the remaining rear-door link.
NOTE: If you are installing a replacement rear-lower cover, remove the rear-door links from the
discarded cover, and then install them on the replacement cover.
Figure 6-59 Remove the rear-lower cover and rear-door links (duplex product) (6 of 6)
118 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...